• August 25, 2019 at 2:26 pm #28996
    Blank Faceblankface
    Participant

      Here is the track in question: https://soundcloud.com/araelsounds/theres-a-way

      I really like the pad here and tried to recreate but haven’t had much luck. Was able to come up with some nice sounding stuff but its not what I’m looking for.

      Any help would be appreciated!

      August 26, 2019 at 9:45 am #29003
      Colin FowlerColin1970
      Participant

        Which sound in the song are you trying to replicate ? I can just about her a deep bass synth sound if that’s what you’re referring to.

        August 26, 2019 at 10:09 pm #29011
        Blank Faceblankface
        Participant

          It starts at 6 seconds. Best way I can describe it is that it sounds like a vocally pad, not to be confused with the vocal chops that come in at around the same time.

          September 5, 2019 at 9:55 am #29111
          Joe HanleyJoe Hanley
          Keymaster

            Try this:

            Oscillators
            – Osc 1: Medium Pulse Wave, Unison with several voices, but mild Detune, and spread out a bit
            – Osc 2: Same as Osc 1, but pitched up 1 octave, and turn the volume up so these higher notes ring out more than the lower ones
            – Noise: White. Pitch it up or High pass it a bit if you can, so it’s not so bottom heavy.

            Filter 1: Formant filter. This will create the vocal shape. Experiment with the Cutoff, maybe the Res as well, until you get the sound you’re looking for

            Amp Envelope: Medium Attack to swell in, and a long release

            Distortion: A bit of tube distortion to make it a little dirty

            Filter 2: 24 dB Low Pass. Take the Cutoff down to round off the top, but not too far. Boost the Res a lot to make that cutoff peak out and almost self-oscillate

            Reverb: Hall, and pretty wet, like 50/50 Mix.

            September 12, 2019 at 11:52 am #29208
            Blank Faceblankface
            Participant

              Try this:

              Oscillators

              – Osc 1: Medium Pulse Wave, Unison with several voices, but mild Detune, and spread out a bit

              – Osc 2: Same as Osc 1, but pitched up 1 octave, and turn the volume up so these higher notes ring out more than the lower ones

              – Noise: White. Pitch it up or High pass it a bit if you can, so it’s not so bottom heavy.

              Filter 1: Formant filter. This will create the vocal shape. Experiment with the Cutoff, maybe the Res as well, until you get the sound you’re looking for

              Amp Envelope: Medium Attack to swell in, and a long release

              Distortion: A bit of tube distortion to make it a little dirty

              Filter 2: 24 dB Low Pass. Take the Cutoff down to round off the top, but not too far. Boost the Res a lot to make that cutoff peak out and almost self-oscillate

              Reverb: Hall, and pretty wet, like 50/50 Mix.

              Thanks Joe! Hoping to get to your level of skill one day 😀

              September 13, 2019 at 11:01 am #29228
              Joe HanleyJoe Hanley
              Keymaster

                Thanks Joe! Hoping to get to your level of skill one day

                You’ll get there! Keep at it.

              You must be logged in to reply to this topic.