• June 18, 2020 at 11:42 pm #35780
    Jonathan EppeleJonathan Eppele
    Moderator

    Hi! I’m trying to recreate the lead synth that solos at 3:03.

    I use Sylenth1 (preferred synth) and Serum. Any help would be much appreciated. Thanks!

    June 23, 2020 at 2:04 pm #35869
    Joe HanleyJoe Hanley
    Keymaster

    I’m hearing two leads. One is round and plucky, the other is sustained and high pitched on the left side. Which one are you referring to?

    June 23, 2020 at 2:08 pm #35871
    Jonathan EppeleJonathan Eppele
    Moderator

    Sorry, I’m referring to the sustained, high-pitched lead. I wasn’t sure if this patch was doubled and transposed or not.

    July 15, 2020 at 4:54 pm #36130
    Joe HanleyJoe Hanley
    Keymaster

    Sorry for the delayed response! Yes, I think it is doubled and transposed. Try this:

    Oscillator: Two osc, saws, one octave apart. You may have to mess with the start phase of one of the osc in order to hear the two separate saw waves.

    Amp Envelope: Long release

    Filter: Band Pass. Cutoff right around the middle. This will take some bottom off to make it light, and some top off to warm it up a bit.

    LFO: Modulate the pitch with a sine wave. Get that nice pitchy wobble.

    Reverb: Big room, very wet.

You must be logged in to reply to this topic.