• September 7, 2019 at 1:44 pm #29131
    julianmoncadajulianmoncada
    Participant

    Joe,
    Can you share how one can adjust the init preset in serum and save it so it loads up as the default? I remember you went over this in a video but I can’t figure out which one.

    September 10, 2019 at 11:23 am #29175
    joehanleyJoe Hanley
    Keymaster

    I’m not aware of a feature that lets you do that. In the video I mention that once you initialize the synth, all you have to do is change the voice mode to Mono, and it would be just like Syntorial’s synth.

    September 12, 2019 at 12:27 pm #29210
    joehanleyJoe Hanley
    Keymaster

    I take it back. There was a Serum update after we made the Lesson Pack that added the following feature:

    “if you save a preset as default.fxp (or Default.fxp) located in /User subfolder of /Presets, Serum will load this preset on new instantiations of Serum.”

You must be logged in to reply to this topic.